jiangsu zhonghou chemical engineering technology co.,ltd
Jiangsu Zhonghou Chemical Engineering Technology Co.,Ltd.
Add to Cart
Stainless steel ZOKO-OF series ozone contact reaction tank 0.6MPA
Equipment features
It can provide enough space for mixing, contact and reaction of ozone and water. In theory, it is believed that ozone should fully react with bacteria and microorganisms. The longer the contact time, the better the sterilization effect, but the design time is too long, causing the reactor tank to be too large, which will increase the cost and the occupying area. Therefore, the specification design requires the formula C.t≥1.6 to determine the reaction time.
ZOKO-OF series ozone reaction tank body is made of 316L stainless steel material with high anti-corrosion performance, anti-ozone and chloride ion double corrosion resistance. The design fully meets the requirements of C.t≥1.6, and the pressure is 0.6Mpa. The internal design uses advanced water system and reflux baffles to ensure the dissolution of the ozone. No short flow and large mass transfer coefficient make ozone and pool water have sufficient space and time. There is an automatic exhaust valve at the top to send the remaining ozone of the reaction to the residual ozone eliminator to reduce it to O2 and then safely discharge into the outside atmosphere.The tank is equipped with a manhole for easy maintenance.
| Model | Ozone contact reactor |
| Effective reaction volume | According to the ozone disinfection process design and selection, directional non-standard production |
| Certification | 4 years |
| Service life of the equipment | Over 50 years |
| Material | 316L stainless steel resistant to ozone and chloride double corrosion |
| Water distribution and reflux baffle | Stainless steel 316L as material to ensure sufficient contact time and no short flow. |
| Transfer coefficient | Over 90% |
| Surface treatment | Sand blasting and mirror polishing |
| Pressure | The design pressure is 0.6Mpa, the test pressure is 1.5 times design pressure |
| Minimum contact time | C.t≥1.6 |
| Manhole | DN500 manhole in the middle |
